DIY FPV

DIY FPV

rtmp://a.rtmp.youtube.com/live2

== My config ==

FC plug

Departure from FC

BAT and GND output

Bringing BAT and GND to the old ESC

New ESC

V from 5V? or V with BAT?

The red cut wire is 5V

5V connected to the stabilizer

The old ESC had 2 x GND connected
There is no room for two GNDs or 2 x VCCs on the new ESC. You have to decide. Do we connect 5V or VBAT?

5v or VBATThe instructions for connecting a new ESC are simple, but the practice is not. On the old ESC, a connection was made from the FC to a small device through 5v, the same 5v returned to the ESC in place of vcc. Now the question. How to connect it on the new ESC. a) when I connect with BAT, I will be on the safe side, but there will be two bare wires that power a small device at the bottom of the drone b) I will cut the red and black wires of the new ESC and connect 5v and GND to the ESC I will get current on ESC as it was before, but VBAT will still be empty